sw:图文教程
差别
这里会显示出您选择的修订版和当前版本之间的差别。
| 两侧同时换到之前的修订记录前一修订版后一修订版 | 前一修订版 | ||
| sw:图文教程 [2023/05/17 14:52] – [官方案例] liu.ning | sw:图文教程 [2024/05/27 10:22] (当前版本) – [Materials and industrial engineering] liu.ning | ||
|---|---|---|---|
| 行 1: | 行 1: | ||
| ====== 【图文教程】 ====== | ====== 【图文教程】 ====== | ||
| - | ===== 官方案例 | + | ===== 官方教程 |
| + | |||
| + | |||
| + | ==== Medical (easy) ==== | ||
| + | |||
| + | * [[导入和放置CAD植入物：股骨近端]] | ||
| + | ==== Medical (general) | ||
| - | * [[sw: | ||
| * [[髋部和股骨的图像分割]] | * [[髋部和股骨的图像分割]] | ||
| + | |||
| + | ==== Medical (3D printing) ==== | ||
| + | |||
| + | |||
| + | ==== Materials and industrial engineering ==== | ||
| + | |||
| + | * [[气缸盖的图像分割]] | ||
| * [[结合使用涂画和插值工具分割纤维]] | * [[结合使用涂画和插值工具分割纤维]] | ||
| * [[纤维分析]] | * [[纤维分析]] | ||
| + | * [[CAD 与 CAD 的配准]] | ||
| + | |||
| + | |||
| + | ==== General ==== | ||
| + | |||
| + | * [[由图像数据创建 NURBS CAD 模型：脊椎、工业支架、血流]] | ||
| + | * [[Simpleware 中的脚本功能]] | ||
| + | ==== Measurements and statistics ==== | ||
| + | |||
| + | * [[掩膜和模型统计数据：膨胀泡沫模型]] | ||
| + | * [[快速测量：直方图、剖面线、点、距离和角度]] | ||
| + | * [[多标签掩膜和报告]] | ||
| + | * [[壁厚分析]] | ||
| + | ==== Meshing ==== | ||
| + | |||
| + | * [[单个部件的网格细化：股骨近端植入物和椎间盘|]] | ||
| + | * [[网格模型质量检测|]] | ||
| + | * [[由导入的 STL 模型生成 FE 网格|]] | ||
| + | * [[sw: | ||
| + | |||
| + | ==== Physics ==== | ||
| + | |||
| + | |||
| + | * [[在 Simpleware FLOW 模块进行有限元均质化研究]] | ||
| + | |||
| + | |||
sw/图文教程.1684306358.txt.gz · 最后更改: 2023/05/17 14:52 由 liu.ning